Viega Smartpress
Range
General
Flow-optimised press connector system with press connectors made of gunmetal and stainless steel and multi-layer pipes. Multi-layer pipe, dimensionally stable, oxygen seal, colour: white. Press connectors with PPSU support body to ensure the leak tightness and mechanical strength of the connection. Safe and fast connection without widening or calibration of the pipe ends through O-ring-free press technology in all pipe dimensions. For protection pipes are equipped with pipe plugs. Suitable for concealed and pre-wall installations of riser pipes and floor installations.
Multi-layer pipe
Exterior colour white
Suitable for potable water and heating installations
-
Show more
Marking
Manufacturer, pipe dimension, batch, green dot on press end, system approvals
Press connector withSC‑Contur
Inadvertently unpressed connections become visibly leaky when the system is filled.
Viega guarantees the detection of unpressed connections in the following pressure ranges:
Min. water pressure: 0.1 MPa / 1 bar / 14.5 PSI
Max. water pressure: 0.65 MPa / 6.5 bar / 94.3 PSI
Min. air pressure: 22 hPa / 22 mbar / 0.3 PSI
Max. air pressure: 0.3 MPa / 3 bar / 43.5 PSI
Dimensions
d16–63
Tools
The functional safety of Viega press connector systems depends primarily on the faultless condition of the press tools used. For the manufacture of press connections, Viega recommends the use of Viega press tools. Viega press tools have to be regularly maintained by authorised service partners.
Areas of application
Potable water
Heating systems
Rainwater
Compressed air systems
Note
The press connector system ViegaSmartpress is suitable for the creation of potable water installations according to DIN 1988‑200 and EN 806‑2 in consideration of the selection of material in accordance with DIN EN 12502‑1 and according to the evaluation basis for metallic materials in contact with potable water of the Umweltbundesamt (UBA) (Federal Environment Agency). When used for other areas of use and when in doubt about the right selection of material, please contact Viega. Detailed information about applications, restrictions and national standards and directives can be found in the product information, either printed or on the Viega website.
Note – Standards and approvals
Approved for d16–63 in accordance with WRAS approval number 1709382.
Operating conditions for potable water installations
Operating temperature max. 70 °C / 158 °F
Operating pressure max. 1.0 MPa / 10 bar / 145 PSI
Operating conditions heating installations
Operating temperature max. 80 °C / 176 °F
Operating pressure max. 1.0 MPa / 10 bar / 145 PSI
Press connector material
Gunmetal: CC499K
Stainless steel 1.4401
Subject to change without prior notice!
Latest Z- and installation dimensions as well as further technical information can be found on the Viega website and have to be checked before purchase, planning, construction work and use. Our products are continuously optimised.
This product description contains important information on choice of product and system, mounting, commissioning as well as intended use and, if required, on maintenance measures. This information on products, their features and application techniques is based on currently valid standards in Europe (e.g. EN) and/or in Germany (e.g. DIN/DVGW). Some passages in the text may refer to technical regulations in Europe/Germany. These should be considered as recommendations for other countries where no corresponding national requirements exist. The relevant national laws, standards, regulations, directives and other technical provisions take priority over the German/European directives specified in this product description: The information herein is not binding for other countries and regions and should be understood as recommendation.

Downloads
Keine Ergebnisse